I'm not using the anti-moan brackets, so I hope that works out ok. Agree with the holes in the perches being too large. I found some tubing of the correct ID OD and just welded them into the holes. I copied the 8" angle, which I believe was 3* UP, not down.
Also, I have a 50" driveshaft. It is too long, but I'm going to try it anyways. It's just about touching the tranny with the suspension bottomed out.. But when I jack the rear end up to simulate loading, the slip joint slides out (Whcih i found odd, but no matter)..
|
