torque box install questions
ok, i am ready to install my driver side torque box. i got the m117 if that helps to know. i have a few questions before i finish the install, i also had to install the lower subframe rail patch and the front part of the floor support. i have them in the car and have them the way i want them. i looked at the fit of the torque box and noticed it fits a bit tight but seems like it should work well. if i try to go strait up with the box it hits the little lip in the floor support, do i have to take it up on an angle? go in from the front? or should i just notch that little lip and then weld a small piece back in so it looks normal when i am done? i really don't want to split the thing and from what i understand you should not have to on a coupe. also when i put the toe board in does it go under the floor or over it or should i just cut the over lap out and butt weld the two together like i will at the trans tunnel?
__________________
current project.... 68 6cyl coupe 3spd w/o turn signal hood, next project... 68 6cyl coupe automatic w/turnsignal hood.
|
