i got a 1967 mustang and the floor pans is rusted out and the trunk is also would a 1 piece fit in it with the top and fenders on or would i have to buy pieces seperate
If you car needs that one piece floor pan along with the trunk you might as well part it out or scrap it. Thats like the entire bottom of the car and cost $2300 just for the part. There is no way I would go that route especially on just a coupe. You can find a good solid roller for $2300
Right, I know where a nice 6 cyl 1965 is and the owner is asking $2500. I bet you could get her for $2K. It's located just 5 houses down from where my new '66 was parked. See Atlanta Craigslist. Save your money. You have a donor.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Vintage Mustang Forums
4M posts
89.2K members
Since 2001
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!