General Discussion
Classifieds
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
VMF Chapters
Local Area VMF Chapters
Latest Posts
-
I'm not sure if this is the correct forum section for this question, if not please advise :) I've got a car that needs to be entirely stripped. (paint, bondo, rust) What is the preferred method from those that have been through this process. Dipped chemical stripping, sand blast / media blast...28 replies 390 views
-
Last week, we turned the car on. All of the sudden the belts quit turning so we quickly turned the car off. We did find some roller bearing on the ground after with what looked like part of a retainer. The bearing did not have any fluid on them nor were they hot. Since then, we cannot get the...9 replies 118 views
-
i must've posted this 10 times. its really bugging me. car stalls when put into gear. i know idle rpm should be at 475-500 in park but that'll never happen. but even if curb idle is at 1500, i throw her into gear and it shakes like a brick in a dryer then just dies. i checked carb adjustments...4K replies 150K views
-
Hey! I recently bought this 67 coupe and have been working on sanding down to bare metal in preparation for paint. While scraping out the rear windshield I noticed a crack in the body work and pulled out all of this silicone putty stuff. It would have had to go anyway to do some surface rust...10 replies 219 views
-
Well thanks to so many people on this forum who have helped me along the way with wiring up the Duraspark II setup to other helpful advice. It finally burrs again. Now onto buttoning up all the loose ends and see how this thing runs on the road. Things I've done since its been sitting. Link to...0 replies 0 views