General Discussion
Classifieds
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
VMF Chapters
Local Area VMF Chapters
Latest Posts
-
Last week, we turned the car on. All of the sudden the belts quit turning so we quickly turned the car off. We did find some roller bearing on the ground after with what looked like part of a retainer. The bearing did not have any fluid on them nor were they hot. Since then, we cannot get the...23 replies 362 views
-
I am starting to plan my next build. I have used modular engines in past builds but want to do something more traditional looking for the next one. I want to build up my engine from a short block. I am leaning toward a 363 with an aftermarket block to deal with the 500 plus HP the engine will...26 replies 591 views
-
I have a 66 fastback which despite adjusting the park brake to be as good as it can be is still weak to hold the car on any incline. The brake shoes are in good condition and reading the many forums, the poor park brake performance is a common issue. My car is manual so hill starts are my main...31 replies 531 views
-
So I've been the proud owner of a 1970 Mach 1 since shortly before the winter. I haven't had the chance to drive it much over the last months but very much look forward to getting it to stretch its legs very soon! I noticed it has struggled shifting gears properly when cold. I suspect I need to...2 replies 74 views
-
I'm not sure if this is the correct forum section for this question, if not please advise :) I've got a car that needs to be entirely stripped. (paint, bondo, rust) What is the preferred method from those that have been through this process. Dipped chemical stripping, sand blast / media blast...29 replies 448 views