Vintage Mustang Forums - View Profile: Opentracker

Opentracker Opentracker is offline

Supporting Vendor

  Visitor Messages

Showing Visitor Messages 1 to 7 of 7
  1. Opentracker
    12-19-2016 01:28 PM - permalink
    Yes, we have a 25% off special going on the Porterfield R4-S brake pads/shoes. The deal applies to shoes, pads or a combo of the two. You can find the links in the deals section of the VMF.

    VMF Deals - Vintage Mustang Forums

    We always discount products for VMF members. Some of our products have a steeper discount than others. If you have a wish list, I can give you a quote with the discounts available.
  2. MrRon1
    12-19-2016 11:35 AM - permalink
    Are u guys running any specials at year end?
  3. Opentracker
    09-14-2016 08:39 PM - permalink
    Hi Jared,

    Our manual kit is $579, with the power upgrade it's $749. This is for a car that came with stock drum brakes. Does it have drum brakes?

  4. Jakal
    09-14-2016 05:29 PM - permalink
    Good afternoon,

    I'm curious about the Ford-Hayes disc brake conversion kits for my '69 Mustang. Are the website prices still good?


  5. dmiller369
    04-22-2016 02:24 PM - permalink
    can i have an email address to discuss suspension components. Or just email me at when you get this.
  6. sixtyfourandahalfcoupe
    02-23-2016 01:21 PM - permalink
    John, good morning I hope you are doing well. I am getting this popping sound from my suspension when I go in reverse and when I turn. I'm thinking it's most likely my upper control arms as when I replaced them last time I used Scott Drake parts.

    I have a few questions for my mainly street driven car do you think your stock upper control arms will work well with my set up. I have roller spring perches, roller lower arms, roller idler arm and adjustable strut rods, along with bilsten street shocks and also coil springs which I purchase from you.

    The car rides fine for the most part but I want to buy the upper control arm only once and not have to replace them again for a while. So I'm not sure if the stock upper control arms will work or if I should step up to the roller upper control arms.

    Any help would be greatly appreciated and thank you for your time.
  7. fast65ford
    02-12-2013 08:43 PM - permalink
    Was wondering if you were going to run a spring special similar to this post ...

  About Me

  • About Opentracker
    Carmel Valley, Calif.
    Opentracker Racing Products - We build vintage legal racing suspension componets for Mustangs and ot
  • Signature
    Proud VMF Sponsor

    Vintage Mustang Suspension


Total Posts
Visitor Messages
General Information
  • Last Activity: Yesterday 05:58 PM
  • Join Date: 03-20-2001
  • Referrals: 2


Showing Friends 1 to 4 of 4


No results to display...


09:55 PM - Huskinhano quoted Opentracker in post HUGE Shoutouts and MANY Thanks!
That is great news. Congratulati...
03:28 PM - Opentracker quoted dennis111 in post '66 GT brake pad & shoe recommendations?
Can't edit previous post but j...
01:58 PM - Opentracker quoted ruger in post Nice surprise: Moog upper control arm
If I cannot get Moog then ...
12:56 AM - BlakeTX quoted Opentracker in post Nice surprise: Moog upper control arm
...per Control Arms - Opentracker Racing Products h...
03:27 PM - Opentracker quoted sw3028 in post Center Link Bushing Replacement
So I got new bushings for t...
04:00 PM - MikeG69 quoted Opentracker in post Planning a disc brake conversion
...der, you get a free Opentracker Racing T-Shirt ! ...
08:15 PM - Flade quoted Opentracker in post New Shock Tower Reinforcement Question
...e kit (1967-1970) - Opentracker Racing Products h...
07:12 PM - Opentracker quoted Woodchuck in post Looking for rear disc suggestions.
Are you sure that this would w...
04:37 PM - Woodchuck quoted Opentracker in post Looking for rear disc suggestions.
...Bearing Ford Rear - Opentracker Racing Products A...
01:48 PM - dads68stang quoted Opentracker in post Lowering springs too short?
Most of the time, our springs go...
03:09 PM - Jed2009 quoted Opentracker in post Where to Buy 11/16"-18 Nut?
I have some here you can have fo...
03:00 PM - 4ocious quoted Opentracker in post Where to Buy 11/16"-18 Nut?
I have some here you can have fo...
03:00 PM - Huskinhano quoted Opentracker in post Where to Buy 11/16"-18 Nut?
I have some here you can have fo...
01:29 PM - Opentracker quoted j persons in post Clutch pedal retaining clip
I disassembled my pedal suppor...
03:37 PM - Huskinhano quoted Opentracker in post Help me upgrade my suspension! grab-a-trak didnt last
...ible. Contact - Opentracker Racing Products ...
01:53 PM - Opentracker quoted Huskinhano in post Help me upgrade my suspension! grab-a-trak didnt last
Sorry I'm late to the party. A ...
09:20 PM - silverblueBP quoted Opentracker in post Anyone need a 20' enclosed car hauler?
Can you deliver to Calif ? I ...
08:31 PM - Opentracker quoted zray in post Are brakes important on vintage Mustangs? ?
04:42 PM - Aquarius quoted Opentracker in post Shifting leaf springs/shackles
...SIZED how fantastic Opentracker has been to deal wit...
04:31 PM - Opentracker quoted Aquarius in post Shifting leaf springs/shackles
Opentracker 4.5 Mid eye 1" dr...


iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
Members who left positive:
Members who left negative:
Total positive feedback: 0
Submit Feedback
6 Months
12 Months
Positive Positive 0 0 0
Neutral Neutral 0 0 0
Negative Negative 0 0 0
For the best viewing experience please update your browser to Google Chrome