65 radiator with serpentine belt

[2late]

I was wondering if anyone is using this set-up and if so what do you do for the lower hose when using the reverse rotation pump with RH outlet? For several years I have just used two hoses connected with a pipe but even though nothing shows but the clamps it is not a really clean looking solution. Does any company make a hose for this set-up? I have searched through the stocked hoses in several auto parts stores with no luck so far.

[gotstang]

Several people here are using a 2.9L BroncoII upper hose trimmed to fit, seems to work very well and look like it belongs.

[2late]

Thanks I will check that out. I have been under the car quite a bit lately and that darn hose just don't look right.

[copasspupil]

The upper hose from a bronco works. Ron Morris made a lower metal hose but it did not for me at all. You can take the car to a radiator/muffler shop and have some aluminized pipe made to fit. That is what I did.

[2late]

I just noticed a typo in my first post, I said a RH outlet when it actually is a LH. I have two hoses connected in the middle with a stainless steel pipe and all of the pipe is hidden but there is the two clamps showing, does not look that bad maybe I am just being too picky.

[copasspupil]

I photo would help.

[gothand]

I'm using a Bronco II lower hose with manual transmission for my UPPER hose and a regual '70 lower hose with a few inches trimmed off for my lower hose.