It has been awhile since I last posted, but got my gt40 stage 2 porting back from the shop and ready to put on here in a week. Measured the pushrod length and it's 6.905 and the closest pushrod I found so far is 6.900 by TF and Crane. So the question, in .005 going to make a differece or get custom length to the accurate measurements?
If you have hydraulic lifters you should be fine, I don't know about solids. If you are really concerned about it you could get some lash caps for your valve stems, and then remeasure to see if you come closer to a stock length, but I don't think it would be worth the trouble. 0.005 is well beyond most manufacturing tolerances.
The AutoGuide.com network consists of the largest network of enthusiast-owned enthusiast-operated automotive communities.
AutoGuide.com provides the latest car reviews, auto show coverage, new car prices, and automotive news. The AutoGuide network operates more than 100 automotive forums where our users consult peers for shopping information and advice, and share opinions as a community.
Pushrod ?
