I am installing my new Weiand intake and carb and have a couple questions. Can I use the power brake vacuum port on the back of the 1403 Edelbrock carb for the PVC instead of the front port?
I also bought a new water neck from Summit which has the O-ring seals. Should I use sealer with the O-rings?
I am also planning on using Aviation form-a-gasket sealant on the Felpro intake gaskets. The gaskets I bought are the good ones with the blue seal strip around each of the ports. Is this overkill?
66 coupe, 289, Edelbrock carb, Weiand 8011 intake, Pertronix Ignition, Hipo exhaust manifolds, 2" dual exhaust, WC T5 trans, 3.25 gears, KH 11" front disc, Hawk HPS pads, stock rear drums, 1" front sway bar, rubber bushings, Shelby quick steer kit, GT progressive rate coils, 4.5 leaf mid-eye, KYB Gas-A-Just front & GR-2 rear, export brace, Monti-Carlo bar, Global West sub-frame connectors, performance alignment, 16" x 7" wheels, 215/55/16 and 225/55/16 Toyo Proxes4 tires