Motor Mounts - 69 Mach1

mordi · 06-20-2003, 09:39 PM

What are the correct motor mounts for a 69 Mach 1 with a 351W?

Are there more than one type available? Where can I purchase them?

How difficult are they to install?

Thanks,
Mordi

Hemikiller · 06-20-2003, 10:13 PM

No, just one type, same on both sides. Anchor # is 2287. Your local parts store should have them on the shelf, they were used in many many different vehicles.

Installation is as simple as removing one through bolt, jack the motor up, unbolt from engine block, install new mount, lower, insert through bolt, repeat for other side and tighten through bolts when finished. Just use a block of wood under the pan when jacking the motor, or better yet, use and engine hoist....

mordi · 06-20-2003, 10:32 PM

Hemikiller,

Thanks for the info.

How can I tell if the mounts are indeed worn? My transmssion lines are very close to my fan blades and I am guessing the problem is the mounts?

Thanks,
Mordi

70_DropTop · 06-20-2003, 11:44 PM

This is a little something that I discovered when installing mine...Click on Tips below...

Motor Mount Install Tips

mordi · 06-20-2003, 11:53 PM

Cool tip!

So, how long does it take to change the mounts?

Thanks,
Mordi

70_DropTop · 06-20-2003, 11:59 PM

Less than an hour even if you take your time. (Providing all goes well)

Scott