General Discussion
Classifieds
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
VMF Chapters
Local Area VMF Chapters
Latest Posts
-
So I've been the proud owner of a 1970 Mach 1 since shortly before the winter. I haven't had the chance to drive it much over the last months but very much look forward to getting it to stretch its legs very soon! I noticed it has struggled shifting gears properly when cold. I suspect I need to...2 replies 71 views
-
I'm not sure if this is the correct forum section for this question, if not please advise :) I've got a car that needs to be entirely stripped. (paint, bondo, rust) What is the preferred method from those that have been through this process. Dipped chemical stripping, sand blast / media blast...29 replies 442 views
-
Last week, we turned the car on. All of the sudden the belts quit turning so we quickly turned the car off. We did find some roller bearing on the ground after with what looked like part of a retainer. The bearing did not have any fluid on them nor were they hot. Since then, we cannot get the...21 replies 299 views
-
Hello all, I want to lower my car 2". I am running standard coil springs with 205/60/15 tires. I am leaving the same tires. Ideally, I want to use progressive coil springs, but from what I have read, they go down no more than an inch. The only coil springs that I have found to be able to lower...46 replies 852 views
-
Hello everyone, I have a vintage 1960's o.e.m. FoMoCo reverberation unit that I would like to install in my 1965 Mustang hardtop. I understand that they may have been either factory or dealer installed. If factory installed, does anyone know where the installation spot would have been?8 replies 268 views