General Discussion
Classifieds
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
VMF Chapters
Local Area VMF Chapters
Latest Posts
-
I'm not sure if this is the correct forum section for this question, if not please advise :) I've got a car that needs to be entirely stripped. (paint, bondo, rust) What is the preferred method from those that have been through this process. Dipped chemical stripping, sand blast / media blast...30 replies 480 views
-
I read on Holleys website that these efi units can not be used on any vehicles newer than 1966? But it seams like everybody has one.0 replies 0 views
-
Thought I would introduce myself as a new member. I just picked up a project 1965 4 speed A code coupe. I plan on doing a full frame up restoration. While I am not new to the restoration program, having done 3 since I retired, this will be my first mustang restoration. My first car in high...3 replies 56 views
-
Last week, we turned the car on. All of the sudden the belts quit turning so we quickly turned the car off. We did find some roller bearing on the ground after with what looked like part of a retainer. The bearing did not have any fluid on them nor were they hot. Since then, we cannot get the...26 replies 537 views
-
Hey VMF’ers, I am in need of a new 68 drivers door. Mine is to far gone for my abilities. Most of the metal on the inside and outside of the forward bottom door is rotten or caved in with 1/2 bondo. Most of the damage is in the lower rear section of the door by the body line so it’s very hard...0 replies 3 views