1968Cally 1968Cally is offline
- About 1968Cally
- Hawthorn Woods, Illinois
- Car Guy
|08:54 AM - 1968Cally quoted IndyFive-O in post 1967 mustang shop manual
PaperbackBut pretty sturdy.
|08:51 PM - 1968Cally quoted Grimbrand in post Timing Question
3) If your throttle blades ar...
|08:09 PM - ipmaham quoted 1968Cally in post Timing Question
The first thing that you have ...
|08:04 PM - 1968Cally quoted ipmaham in post Timing Question
Just got back from messing w...
|08:43 AM - 1968Cally quoted Woodchuck in post Bad vibrations
... the engine.Thanks, Woodchuck. Good tips to help ...
|09:54 AM - 1968Cally quoted watto1 in post Bad vibrations
How's your transmission mou...
|05:24 PM - 1968Cally quoted gt350sr in post Deadbeat bidders on Fleabay
Is this a new 'thing', or am...
|07:54 PM - 1968Cally quoted macstang in post I guess shopvac's are not indestructable
I have never seen an antique ...
|09:33 PM - 1968Cally quoted IndyFive-O in post Concours d'Lemons
OK, I realize this goes in the ...
|02:08 PM - Flade quoted 1968Cally in post Couple of questions on AC in a 68
Pretty sure the thermostatic s...
|12:43 PM - 1968Cally quoted Flade in post Couple of questions on AC in a 68
If you bypass the A/C swit...
|10:11 AM - 1968Cally quoted Winch in post Couple of questions on AC in a 68
I went back over all the p...
|09:37 AM - 1968Cally quoted Winch in post Couple of questions on AC in a 68
I'm a little confused on w...
|07:20 PM - mikeyhunts quoted 1968Cally in post Bullitt going on the block
What is the over/under on the ...
|07:12 PM - 1968Cally quoted GypsyR in post Why do we over-describe?
Perhaps people are used to ...
|02:59 PM - 1968Cally quoted awhtx in post 1968 Mustang Stalls at lights
A 500 rpm drop from P to R...
|11:55 AM - 1968Cally quoted j persons in post Bullitt going on the block
IMO, with that mindset, you sh...
|11:42 AM - scootr117 quoted 1968Cally in post Bullitt going on the block
I would hope that the Smithson...
|08:32 AM - KillaBeave quoted 1968Cally in post Bullitt going on the block
Is this one one that got cut u...
|10:14 PM - 1968Cally quoted donkeykong in post Bullitt going on the block
OR there's the possibility that...
|iTrader Profile||Recent Ratings|