Vintage Mustang Forums - View Profile: GypsyR
Supporting Member

GypsyR GypsyR is offline

Just some guy

  Visitor Messages

Showing Visitor Messages 1 to 10 of 23
  1. JSHarvey
    08-29-2019 10:48 AM - permalink
    JSHarvey
    Thanks for the tip on the image hosting site. I'll try to get it fixed/resolved today or tomorrow. :-)

    John Harvey
  2. 67 Evil Eleanor
    08-05-2019 10:51 AM - permalink
    67 Evil Eleanor
    Sorry for not being active lately but real life gets in the way. Cancer has hit hard within the family. Wife (shes free now), mom and her live in both have cancer, and it's not looking too good but anyway. I have a question on the 4r70w. It's having trouble down shifting like from OD to a lower gear. It will bog down quiet a bit before it shifts. Actually the tranny has never shifted like I'd think it would especially on the OD side bogging down. We have been driving the car and have put about 900 miles on it. On a scan it shows the VSS is bad. I have replaced this a couple of times and tried to move it to the tail shaft where the speedo hooks in. The tranny is very consistent so I'm thinking it's a input problem. I checked the TPS voltage and it was 5.1 on the top end. Also there's no adjustment unless I reem the sensor holes out a little.
  3. Mustangerbob1
    07-26-2019 09:13 AM - permalink
    Mustangerbob1
    Quasi Partially logged in.

    I am logged in, but apparently not logged in.

    Welcome, Mustangerbob1. Visited Yesterday 06:35 PM Private Messages: Unread 0, Total 90.

    When I click on some of the picture links, it states I am not logged in, and asked for a log in, and then rejects it.

    Any idea? Thanks Bob
  4. rwg67
    07-11-2019 08:01 AM - permalink
    rwg67
    I have made the corrections below. The 17 x 8's need to have a 4.75 bs and i stated 4.5. Then cut and paste and my error is repeated. Thanks.

    According to dodgestang
    All: 17x8 with 4.75 bs and 235/45R17s (closest to my setup)

    According to Mustang Plus
    All: 17x8 with 4.75 bs and 235/45R17s

    According to Vintage Mustang Wheel and Tire
    Front:17x8 with 4.75 bs and 235/45R17s
    Rear: 17x8 with 4.75 bs and 235/45R17s

    According to CJ Pony
    Front:17x7 with 4.25 bs and 225-235/45R17s
    Rear: 17x8 with 4.75 bs and 245/45R17s

    According to Legendary Wheel
    Front:17x7 with 4.25 bs and 225-235/45R17s
    Rear: 17x8 with 4.75 and 245/45R17s *
    *Test fit the 17x7 from the front on the rear to see if I can go with the 17x8

    I purchased the following
    Front Rim:17x7 with 4.25 bs
    Rear Rim: 17x8 with 4.75 bs
  5. John_in_SC
    06-21-2019 08:34 PM - permalink
    John_in_SC
    Hey brother - you may want to lock my thread up about the charger. Looks like it may be taking an turn for the worst......just letting you know.
  6. rwg67
    06-16-2019 05:04 PM - permalink
    rwg67
    GypsyR,

    Is it possible to edit original posts? I have wrong info that I would like to correct.

    Thanks,

    Ron
  7. gjz30075
    05-27-2019 06:26 AM - permalink
    gjz30075
    GypsyR, can you please delete this ad:
    https://forums.vintage-mustang.com/1...ing-valve.html

    It is in the wrong forum. I already recreated it in the proper forum.
    Thanks!
    Greg Z
  8. rwg67
    04-30-2019 03:31 PM - permalink
    rwg67
    GypsyR, See your post and comments on VMF and really appreciate your insight. Have utilized your feedback more than once. The reason I am reaching out to you is to determine why a recent post of mine is no longer visible from 4/29/19. It was a tire and rim question that has been brought up before, but I was asking in anyone else had figment issues due to UCA lowering, mideye lowering, etc.

    Still trying to secure VMF thoughts before I spend over $1000 to make sure it will work.

    Regards,
    Ron
    Member: rwg67
  9. DonP
    02-07-2019 03:13 PM - permalink
    DonP
    Hello GypsyR,

    Can you please remove my personal email address from post #148 of;

    https://forums.vintage-mustang.com/m...l#post10102310
    ?
    Thank You
  10. 67 Evil Eleanor
    08-09-2018 05:42 PM - permalink
    67 Evil Eleanor
    Car is now shifting great. Changing the gear made a world of difference. Running a 21 bou would love to have a 22. So far I can't find one and think none of those were made. That truck of yours is calling, please change my gear LOL. If you do, let me know how it worked. Going to buy another Lincoln MK 8. Only 250 bux and it runs like a top. Now for something to put it in. Started the "J" code Mach One. Pretty well stripped and will be on the rotisserie in a few days. Thinking about a 557. Course will keep all the original stuff. Miss the days when I could drive the Track car down Broad Street and set off all the car alarms. Naaaaa, I wouldn't do that.

  About Me

  • About GypsyR
    Biography
    Currently abusing an innocent rusty 6 cylinder '67 coupe and getting paybacks from an awful '69
    Location
    SC foothills, USA
    Interests
    Cars, motorcycles, computers, model cars, airbrushing, drawing, painting, machine work, mostly
    Occupation
    Mechanic
  • Signature
    .... it wouldn't be the first time reality took theory and conjecture out behind the woodshed and gave them a good thrashing.
    I have some cars. With a long list of parts on them that if anyone was interested in, they'd ask.

  Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: Today 09:38 PM
  • Join Date: 06-07-2001
  • Referrals: 1

  Friends

Showing Friends 1 to 2 of 2

  Mentions

09-21-2019
10:06 PM - 2nd 66 mentioned GypsyR in post Anyone need floor pans?
GypsyR Israel patrickstaple...
08-25-2019
10:12 PM - vegasloki mentioned GypsyR in post Synthetic Oil
GypsyR the label shows that...
07-18-2019
10:02 PM - vegasloki mentioned GypsyR in post Thermostat
...uck, Mustang4SF and GypsyR explain the engineer...
07-10-2019
08:16 PM - Groundpounder17 mentioned GypsyR in post Dodgestang Wheel and Tire fitment guide
GypsyR, I didn’t know...
07-06-2019
12:02 AM - Turnall mentioned GypsyR in post Sacramento County: Illegal to Work on Your Own Car in Your Own Garage
...but as moderators ( GypsyR, Israel, patrickst...
06-25-2019
09:46 PM - patrickstapler mentioned GypsyR in post Help with site please!
GypsyR should be able to re...
09:23 PM - alex1965 mentioned GypsyR in post "The Right Stuff" -- Your Experience
...s, just so you know GypsyR ! Thanks all for ...
05-21-2019
05:15 PM - PA_cob mentioned GypsyR in post Dreaded over heating topic again...I know guys sorry
GypsyR I keep hearing about...
05-06-2019
04:08 PM - 66ryan mentioned GypsyR in post Dreaded over heating topic again...I know guys sorry
GypsyR would you say none o...
04-07-2019
01:50 PM - jgrote mentioned GypsyR in post Intermittent NO Start - Start
GypsyR is totally correct. ...
03-12-2019
04:09 AM - Mustang4SF mentioned GypsyR in post Wow, what a difference some new points can make
GypsyR Thanks for the recom...
03-11-2019
02:50 PM - GypsyR mentioned Mustang4SF in post Wow, what a difference some new points can make
Mustang4SF, thanks for replying...
10:32 AM - Mustang4SF mentioned GypsyR in post Wow, what a difference some new points can make
... something fancy. GypsyR At the first time, m...
03-01-2019
05:28 PM - PA_cob mentioned GypsyR in post Serpentine vs V-belt
GypsyR would the pulley on ...
01-10-2019
09:24 AM - Grabber70Mach mentioned GypsyR in post OEM PMGR Mini Starter!?
GypsyR is there an OEM PMGR...
12-05-2018
03:58 PM - 2nd 66 mentioned GypsyR in post 302 internals in 289 block
...free PDF down load GypsyR may I paste it or no...
11-18-2018
01:57 PM - Turnall mentioned GypsyR in post Won’t idling
...l, patrickstapler, GypsyR Allen
11-09-2018
09:28 AM - markb0729 mentioned GypsyR in post c4 engaging problems
If IIRC GypsyR may have some insigh...
09-06-2018
09:10 PM - Turnall mentioned GypsyR in post RIP Burt Reynolds
...el, patrickstapler, GypsyR. Allen
06-07-2018
10:33 PM - GypsyR mentioned jgrote in post Cooling issue. Throwing the kitchen sink at it.
...I finished I (like jgrote) will KNOW what all ...

  Quotes

10-17-2019
02:30 PM - wicked93gs quoted GypsyR in post Anyone ever shave the front headlight door "gills"?
Wouldn't really be an issue...
10-16-2019
07:43 PM - GypsyR quoted BigKoppa in post Interesting item for sale on Facebook
I don't have a facebook accou...
02:50 PM - 65 Pony quoted GypsyR in post Interesting item for sale on Facebook
I could see it for myself i...
02:41 PM - BigKoppa quoted GypsyR in post Interesting item for sale on Facebook
I could see it for myself i...
11:29 AM - 2nd 66 quoted GypsyR in post Interesting item for sale on Facebook
And for people who don't ha...
10-15-2019
11:03 PM - BlakeTX quoted GypsyR in post Interesting item for sale on Facebook
And for people who don't ha...
09:59 PM - Nailbender quoted GypsyR in post Does a 65 have reverse back up lights?
Next time someone wants to ...
10-13-2019
12:18 PM - cturboaddict quoted GypsyR in post Commenting on sale ads
Hmm, I pushed the buttons b...
11:15 AM - cturboaddict quoted GypsyR in post Commenting on sale ads
...-shelf font.) Welp GypsyR... Still cannot com...
10-12-2019
05:29 PM - cturboaddict quoted GypsyR in post Commenting on sale ads
... Much appreciated GypsyR. I don't have th...
10-11-2019
01:49 PM - GypsyR quoted sportsroof69 in post How much $$$$ for a 414 Stroker??
I know because I've done it.........
10-10-2019
09:10 PM - Alex Tugbang quoted GypsyR in post Want to sell a lot of original parts off my 69 grande but cant because of forum
The "for sale rules" are th...
10:40 AM - DrHawkeye quoted GypsyR in post Gladly "out of step." No popcorn for me.
Won't hurt either. That's a...
10:36 AM - GypsyR quoted Lizer in post Gladly "out of step." No popcorn for me.
1 hr a week isn't going to...
10-09-2019
03:02 PM - JEFFinOC quoted GypsyR in post Will a 67 clutch pedal asm work in a 68?
There's a home made tool th...
10-07-2019
10:39 AM - GypsyR quoted Sh123 in post Deleted Posts
10-04-2019
03:23 PM - Mustangerbob1 quoted GypsyR in post Why were straight 8 engines a thing?
"Funny how good ICE is gett...
02:31 PM - GypsyR quoted malarson in post Cheap Money
Hell, our cellphones, cable/i...
10-02-2019
09:41 AM - hsvtoolfool quoted GypsyR in post "Poly" Paints
Unless someone knows of or ...
09-26-2019
03:06 PM - Russstang quoted GypsyR in post My bad dog...
Please don't quote spammers...

  Garage

    1967 Ford Mustang
    1967 Ford Mustang
    1995 Ford F150
    blue truck
    1969 Ford Mustang
    Pile of ....
    1986 Ford Mustang
    Powder Puff
    1981 Volkswagen Caddy
    yellow truck

  Feedback

iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
Submit Feedback
  Past
Month
Past
6 Months
Past
12 Months
Positive Positive 0 0 0
Neutral Neutral 0 0 0
Negative Negative 0 0 0
 
For the best viewing experience please update your browser to Google Chrome