Whats the car worth 67 S-Code FB - Vintage Mustang Forums
 1Likes
Reply
 
Thread Tools
post #1 of 18 (permalink) Old 11-13-2017, 12:36 PM Thread Starter
Member
 
Join Date: Aug 2016
Location: Socal
Posts: 49
Whats the car worth 67 S-Code FB

So there is this car that's seen better days, and I would like to know what you guys think the cars worth as it sits. as you can see the roof has damage, doesn't have the 9" rear, and no engine trans or interior. basically the doors and fenders aren't original to the car. also looks like it needs a new complete floor assembly and front frames. only thing the car in my opinion is its a S-Code

1965 Mustang Fastback GT (All Original Rust Bucket)
1965 Mustang Fastback A-Code (Getting There)
1968 Mustang Fastback GT (In Works)

Last edited by jruiz555; 11-14-2017 at 08:16 PM.
jruiz555 is offline  
Sponsored Links
Advertisement
 
post #2 of 18 (permalink) Old 11-13-2017, 12:42 PM
Senior Member
 
kenash's Avatar
 
Join Date: Dec 2006
Location: Severna Park, MD
Posts: 6,210
Garage
IMHO, a couple hundred....maybe? Might get more for scrap value.

KenA..
64 1/2 Poppy Red Cvt. Resto-Mod
333 Cu.in. T5z, 3:55, Dual 40 mm DCOE Webers
Performer RPM, CI cam, TFS/TWs, Tri-Ys, Discs w/Shelby Drums
Severna Park, Maryland
kenash is offline  
post #3 of 18 (permalink) Old 11-13-2017, 12:51 PM Thread Starter
Member
 
Join Date: Aug 2016
Location: Socal
Posts: 49
haha yea i agree, i gave it a ball park calculation, and just to get the car rolling with parts (correct engine, 9" rear end and trans along with sheet metal about $12,000)

1965 Mustang Fastback GT (All Original Rust Bucket)
1965 Mustang Fastback A-Code (Getting There)
1968 Mustang Fastback GT (In Works)
jruiz555 is offline  
 
post #4 of 18 (permalink) Old 11-13-2017, 01:12 PM
Senior Member
 
kenash's Avatar
 
Join Date: Dec 2006
Location: Severna Park, MD
Posts: 6,210
Garage
yeah, and conservative and performing the work yourself!

KenA..
64 1/2 Poppy Red Cvt. Resto-Mod
333 Cu.in. T5z, 3:55, Dual 40 mm DCOE Webers
Performer RPM, CI cam, TFS/TWs, Tri-Ys, Discs w/Shelby Drums
Severna Park, Maryland
kenash is offline  
post #5 of 18 (permalink) Old 11-13-2017, 01:20 PM
Senior Member
 
sixtysevenGTconv's Avatar
 
Join Date: Jul 2000
Location: N.H.
Posts: 5,341
Guessing also NO interior included?
Standard or automatic? A standard (per the vin) worth more done.
No one asked, is it a GT optioned car??

My take just a shell, no interior either. Maybe 10-11K, if a factory GT

If you borrow a tool more than twice, you need to own it You get what you pay for!
George email: <[email protected]>
sixtysevenGTconv is offline  
post #6 of 18 (permalink) Old 11-13-2017, 01:53 PM Thread Starter
Member
 
Join Date: Aug 2016
Location: Socal
Posts: 49
I never pulled the marti report, I see the lower strips by the rear quarter panels I think it could be a GT? in the pictures I seen I didn't see a clutch pedal so I assume its an automatic.

sixtysevenGTconv,
in the picture above you believe the car is worth 10-11K as it sits or after all the repairs done you think that's what it would cost?


also lets assume its a GT, what would you pay for it. also keep in mind shipping so add $1500

1965 Mustang Fastback GT (All Original Rust Bucket)
1965 Mustang Fastback A-Code (Getting There)
1968 Mustang Fastback GT (In Works)
jruiz555 is offline  
post #7 of 18 (permalink) Old 11-13-2017, 02:38 PM
Senior Member
 
Join Date: Apr 2011
Location: Poway, CA
Posts: 2,184
Most valuable thing on the car are the Styled steel wheels at $75 each
Asm109 is offline  
post #8 of 18 (permalink) Old 11-13-2017, 04:02 PM
Senior Member
 
sixtysevenGTconv's Avatar
 
Join Date: Jul 2000
Location: N.H.
Posts: 5,341
Quote:
Originally Posted by jruiz555 View Post
I never pulled the marti report, I see the lower strips by the rear quarter panels I think it could be a GT? in the pictures I seen I didn't see a clutch pedal so I assume its an automatic.

sixtysevenGTconv,
in the picture above you believe the car is worth 10-11K as it sits or after all the repairs done you think that's what it would cost?


also lets assume its a GT, what would you pay for it. also keep in mind shipping so add $1500
FYI, maybe it has stripes but would still need to be confirmed to be factory.
I have a friend here on east coast been looking for a '67 390 GT FB for about 4 yrs. I also have a friend that has a few mostly complete but very rough. Between those and SOLD similar cars on Ebay, we figured $15-18k what complete cars worth that NEED resto. Unfortunately my one friend with the cars won't let his go,... yet.

If car you're looking at is a factory S code GT, with both fender apron vin's intact, then I'd think ~ $8-10k is fair. Maybe little lower to $8k because looking at roof and upper rear quarters. Worth the gamble if you can do a lot of the work. Otherwise not a great buy.

If you borrow a tool more than twice, you need to own it You get what you pay for!
George email: <[email protected]>
sixtysevenGTconv is offline  
post #9 of 18 (permalink) Old 11-13-2017, 04:15 PM
Senior Member
 
gt350sr's Avatar
 
Join Date: Mar 2012
Location: Eastern Iowa
Posts: 5,587
Garage
Correct me if I'm wrong- but are you guys saying this car is worth $8K-$11K AS IT SITS? Are you nucking futs? It's a bare shell, right? No interior, drivetrain, no glass, no good sheet metal other than maybe the firewall as he says it needs all else? I'm up for a challenge, but isn't this one pretty much a cap jack?? Not mentioned, but does it even have a clear title ('cause that's all you're buying pretty much)...

Working on old cars teaches us patience... and every curse word imaginable!
gt350sr is offline  
post #10 of 18 (permalink) Old 11-13-2017, 04:42 PM Thread Starter
Member
 
Join Date: Aug 2016
Location: Socal
Posts: 49
GT350, correct bare shell it does have a clean tittle and both aprons with VIN in tact. looking at the car I would say every panel would need to be replaced. its hard to see how this would be worth 8k-10K unless it being a 390 GT FB?

Complete floor is rusted out almost like if it was found in a lake bad.... when you see that then you need to assume the firewall is rusted out and front frames. I would say the aprons in the engine bay are decent. that's the only real good metal/

what if its just a 390 and non GT?

1965 Mustang Fastback GT (All Original Rust Bucket)
1965 Mustang Fastback A-Code (Getting There)
1968 Mustang Fastback GT (In Works)

Last edited by jruiz555; 11-13-2017 at 04:45 PM.
jruiz555 is offline  
post #11 of 18 (permalink) Old 11-13-2017, 06:07 PM
Senior Member
Supporting Member
 
Knapper's Avatar
 
Join Date: Nov 2015
Location: Chaska, MN
Posts: 545
Garage
There is the question of whatís it worth, what is the seller asking, and what is someone willing to pay. I have been looking for over a year now and have seen many in similar condition. Unfortunately worth is determined by mutual agreement between buyer and seller...and there seems to be a number of buyers with more dollars than sense.

The seller will tell you itís a $70k when restored and $15k for the project is a steal. Itíll only be worth $70k after you put 75k into it, plus the purchase price.

Itís frustrating when you are looking for a solid, honest project car. I have seen cars in not much better shape than that go for 20k...Benza had several of them not long ago...only a few now. If the seller is patient, I bet someone will come along and pay 15k for it😫

Last edited by Knapper; 11-13-2017 at 11:36 PM.
Knapper is offline  
post #12 of 18 (permalink) Old 11-13-2017, 06:16 PM
Senior Member
 
Alan _MacDougall's Avatar
 
Join Date: Dec 2009
Location: Pacific NW
Posts: 1,142
Not seeing all the pictures and what you said....2k max. Its looks like a pieced together junk yard car. The roof damage looks like it was from a fork lift. If you can do sheet metal work and what to spend a long long time fixing the body than ok. Really need a donor car also. I personally would run from this car.
Alan _MacDougall is offline  
post #13 of 18 (permalink) Old 11-13-2017, 06:24 PM
Senior Member
 
Join Date: Jul 2000
Location: SF Bay Area
Posts: 8,435
Garage
Let's say if the car were completely done now it would be worth something like $60K. Subtract out the cost in parts and labor to bring the car in the pic to completely done and that's what the pile of parts is worth now.

While I know people pay new dynacorn body prices for cars that look like the one posted here, I do not see the value catching up with the cost any time soon.

url]http://i87.photobucket.com/albums/k156/jefftepper/IMG_0027_edited-1.jpg[/url]

*Principal wrench on this 69 Mach I*
JeffTepper is online now  
post #14 of 18 (permalink) Old 11-13-2017, 06:31 PM
Senior Member
 
69bosssvt's Avatar
 
Join Date: May 2015
Location: Pomfret, Maryland
Posts: 1,751
Garage
You should have $40,800 in it when ur done.....and 40,000 of it will be the restoration.... jmho
gt350sr likes this.

69bosssvt is offline  
post #15 of 18 (permalink) Old 11-13-2017, 10:03 PM
Senior Member
 
sixtysevenGTconv's Avatar
 
Join Date: Jul 2000
Location: N.H.
Posts: 5,341
https://www.hagerty.com/apps/valuati...ang-GT?id=9697
To give you one range of prices based on sold cars I believe, average. These prices I picked for a FB.

If you borrow a tool more than twice, you need to own it You get what you pay for!
George email: <[email protected]>
sixtysevenGTconv is offline  
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Vintage Mustang Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are Off

 
For the best viewing experience please update your browser to Google Chrome